Ranger 4WD V6-3.0L VIN U (1997)
the ball joint studs.
7. NOTE: Mark the orientation of the slot in the camber adjuster. If necessary, scribe a line or mark the position with a grease pencil. The slot should
be installed in the same position during reassembly to maintain alignment.
Remove the camber adjuster sleeve. If required, use Pitman Arm Puller T64P-3590-F to remove the adjuster out of the knuckle.
8. Remove lower ball joint nut.
9. Place knuckle in vise and remove snap ring from bottom ball joint socket if so equipped.
10. Assemble U-Joint Tool T74P-4635-C and suitable ball joint remover on the front suspension lower arm ball joint.
11. Turn forcing screw clockwise until the front suspension lower arm ball joint is removed from the steering knuckle.
12. NOTE: Always remove front suspension lower arm ball joint first.
Assemble U-Joint Tool T74P4635-C and suitable ball joint remover on the upper front suspension upper ball joint.
13. Turn forcing screw clockwise until the front suspension upper ball joint is removed from the knuckle.
Installation
