Ranger 4WD V6-3.0L VIN V Flex Fuel (1999)
14. NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original alignment.
Mark the rear driveshaft.
15. Remove the rear driveshaft.
1
Remove the bolts.
2
Remove the rear driveshaft.
16. If equipped, remove the transfer case.
17. NOTE: If damage is found to the parking gear, the transmission must be removed and disassembled.
NOTE: The parking pawl, parking pawl return spring and parking pawl shaft may fall out during removal of the extension housing.
Remove the extension housing. Discard the extension housing gasket.
