Ranger 4WD V6-4.0L (2009)
Removal
Both sides
1. Remove the camshaft roller followers. For additional information, refer to Camshaft Roller Follower See: Rocker Arm Assembly/Service and
Repair/Removal and Replacement/Camshaft Roller Follower.
RH side
2. Remove the RH hydraulic chain tensioner. For additional information, refer to Timing Drive Components - Hydraulic Chain Tensioner, RH See:
Service and Repair/Removal and Replacement/Timing Drive Components - Hydraulic Chain Tensioner, RH.
3. Install the Camshaft Sprocket Holding Tool and the Adapter for 303-564 on the rear of the RH cylinder head and tighten the top 2 clamp bolts to
10 Nm (89 lb-in).
4. NOTE: The RH camshaft sprocket is a LH-threaded bolt. Turning the bolt in the wrong direction can damage the bolt.
Using the Torque Wrench Extension and the Camshaft Sprocket Nut Socket, loosen the camshaft sprocket bolt.
