Ranger 4WD V6-4.0L (2009)
prevent damage.
If equipped, remove and discard the 3 front axle housing bolts and nuts.
-
To install, tighten to 66 Nm (49 lb-ft).
13. Lower the front axle housing approximately 25 mm (1 in).
14. Remove the LH engine support insulator-to-frame nut.
-
To install, tighten to 103 Nm (76 lb-ft).
15. Remove the LH engine support insulator.
16. If necessary, remove the wiring harness bracket from the LH engine bracket.
17. If necessary, remove the 4 bolts and the LH engine bracket.
-
To install, tighten to 62 Nm (46 lb-ft).
RH side
18. If equipped, remove the RH front coil spring.
19. Remove the RH engine support insulator-to-frame nut.
-
To install, tighten to 103 Nm (76 lb-ft).
20. Remove the RH engine support insulator.
21. If necessary, remove the 3 bolts and the RH engine bracket.
-
To install, tighten to 62 Nm (46 lb-ft).
Both sides
22. To install, reverse the removal procedure.