Ranger 4WD V6-4.0L (2009)
1. Install the TCC solenoid.
2. Install the SSB and SSD solenoids.
3. Install the EPC solenoid.
15. NOTE: The solenoid clamp must be installed in the TCC and EPC solenoid grooves, shift solenoid pockets and the No. 204 plug.
Install the solenoid clamp and the screw.
1. Position the solenoid clamp on the main control valve body.
2. Install the screw.
-
Tighten to 7 Nm (62 lb-in).
16. NOTE: The shift solenoid electrical terminals must face up on installation.
NOTE: The shift solenoids are interchangeable.
Install the SSA and SSC shift solenoids.
17. Install the solenoid clamp and the screw.
1. Position the solenoid clamp on the main control valve body.
2. Install the screw.
-
Tighten to 7 Nm (62 lb-in).