ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Selector Plate > < Output Shaft

Streetka 2003.5 (01.2003-07.2005)

Manual Transmission/Transaxle - Input Shaft Streetka 2003.5 (01/2003-07/2005)
Disassembly and Assembly of Subassemblies

Special Tool(s)

Installer, Extension Housing Bushing/Oil Seal

308-045 (16-015)
General Equipment
Two-leg puller
Press
Materials
Name
Specification
Transmission Oil
WSD-M2C200-C

Disassembly
  1. Using a suitable two-leg puller, remove the ball bearing.
    1. Install the input shaft snap ring.
    1. Remove the ball bearing.

        2. 1. Discard the input shaft snap ring and the ball bearing.

  1. Using a suitable two-leg puller remove the ball bearing.
    • Discard the ball bearing.

Assembly

  1. Coat all components with clean transmission oil before assembly.

  1. NOTE:
    NOTE:Install a new ball bearing.
    Using the special tool and a suitable press , install the ball bearing.

  1. NOTE:
    NOTE:Install a new ball bearing.
    NOTE:
    NOTE:The ball bearing groove must face outwards.
    Using the special tool and a suitable press , install the ball bearing.

Selector Plate > < Output Shaft