Taurus V6-182 3.0L DOHC SHO (1992)
A/C Pulley Snap Ring - Removal
3. Remove the clutch pulley retaining snap ring.
Clutch Pulley Removal
4. Pull the pulley and bearing assembly from the compressor. If the pulley and bearing assembly cannot be removed by hand, use the Shaft Protector
T80L-19703-G and the Pulley Puller D81P-19703-B or T71P-19703-B or equivalent to remove the pulley.
INSTALLATION
1. Clean the pulley bearing surface of the compressor head to remove any dirt or corrosion.
Clutch Pulley Installation
2. Install the pulley and bearing on the compressor. The bearing is a slip fit on the compressor head and, if properly aligned, it should slip on the
compressor head. If difficulty is encountered installing the pulley, gently tap the pulley on the compressor using the Pulley and Bearing Tool
T80L-19703-J. Ensure the pulley bearing is aligned with the compressor head.
3. Install the pulley retaining snap ring with the bevel side of the snap ring out.
