Taurus V6-182 3.0L DOHC SHO (1992)
6.
Push sleeving back and cut wire 8" (200 mm) back from the connector end.
7.
Strip wire 5/16" (8 mm).
8.
Insert wire into butt connector of Service Wire and Connector Assembly (F4VY-14A411-A) and crimp using tool for pro-insulated crimps.
9.
Heat splice with heat gun until tubing shrinks and adhesive flows from each end.
10.
Pull sleeving back over the splice and up to the back of the connector.
11.
Fully tape over the slit and wire up to the back of the connector.
12.
Replace harness retainer and tape it 61, (150 mm) from the end of the connector.
13.
Assemble connector to starter. Insert harness retainer into floating hole on battery cable.
14.
Install negative battery cable.
PART NUMBER
PART NAME
CLASS
F4VY-14A411-A
Wiring And Connector Assembly
AG
D7AZ-19A331-A
Di-Electric Grease
AM
OTHER APPLICABLE ARTICLES: 94-18-3
WARRANTY STATUS:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
OPERATION DESCRIPTION
TIME
942603A
Install Wiring And
0.6 Hr.
Connector Assembly
DEALER CODING
BASIC PART NO.
CONDITION CODE
14A411
X4
OASIS CODES: 201000, 201100, 203200, 601300
