Taurus V6-182 3.0L FF (1995)
4.
Hold the cladding in place and measure the clearance between the cladding front edge and the door sheet metal front edge. The clearance must be
at least 2.7 mm (7/64") to 4.3 mm (11/64"). Refer to Figure 4.
5.
If necessary, lightly push the cladding rearward until it stops to obtain the clearance of 2.7 mm (7/64") to 4.3 mm (11/64").
6.
If the minimum clearance cannot be obtained, remove the cladding and trim the plastic retainer stop on the cladding (up to 3.0 mm) as shown in
Figure 5.
7.
Reinstall the cladding and position as in Step 4 and complete the installation.
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 108000
