Taurus V6-183 3.0L VIN U FI (1993)
5.
Cut the crimped aluminum band which secures the heater by-pass hose to the steel tube assembly. Refer to Figure 1.
CAUTION:
CARE SHOULD BE TAKEN TO ENSURE THAT THE STEEL TUBE IS NOT DAMAGED. A MINI HACK SAW OR HACK SAW BLADE
WITH AN ATTACHED HANDLE SHOULD BE USED.
6.
Disconnect the lower end of the heater by-pass hose from the engine nipple. Discard the constant tension clamp.
7.
Place the new hose clamps (376240-S100, or equivalent) on the new by-pass hose (F4DZ-18472-A).
8.
Install the by-pass hose on the engine nipple and by-pass tube.
9.
Position the hose clamps past the upset bead on both the by-pass tube and the engine nipple.
