Taurus V6-195 3.2L DOHC SHO (1994)
Ignition Control Module: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect both electrical connectors at ICM assembly by pressing down on locking tabs where it is stamped PUSH, and pulling to remove
connector.
3. Remove ICM retaining bolts and remove module.
INSTALLATION
NOTE: The ICM mounting surface must be clean.
1. Apply an even coat of approximately 1/32 inch of silicone dielectric compound or equivalent to mounting surface of ICM.
2. Install ICM, retaining bolts, and torque to 22-31 lb. in. (2.5-3.5 Nm).
3. Connect both electrical connectors to ICM.
4. Connect battery ground cable.
