Taurus V6-232 3.8L (1989)
Fig 27 Heater Core Access Cover Removal
6. Remove four heater core access cover attaching screws and remove access cover and seal from evaporator case.
7. Lift heater core and seals from evaporator case.
Installation
1. Transfer the seal to new heater core.
2. Install heater core and secure into evaporator case.
3. Position heater core access cover on evaporator case and install four attaching screws (Fig. 36).
4. Position blend door actuator to blend door shaft.
Install three screws attaching blend door actuator to evaporator case(Fig 24).
5. Install seal on heater core tubes (Fig. 25).
6. Install vacuum source line through heater core tube seal (Fig. 35).
7. Install evaporator case assembly into vehicle.
