Taurus V6-3.0L VIN 2 Flex Fuel (1997)
2. Install RH differential fluid seal using Output Seal Replacer T86P-1177-B and Output Shaft Seal Replacer Pilot T94P-77001-JH.
3. Install both halfshafts into vehicle.
4. Install front tire and wheel assemblies.
5. Lower vehicle.
With AX4S Transmission
REMOVAL
1. Raise and suitably support vehicle on hoist.
2. Remove front tire and wheel assemblies.
3. Remove both halfshafts from vehicle.
4. Install the Front Cover Seal Remover T74P-6700-A and 5 1/2 inch forcing screw (from tool kit T88T-6701-A) into LH differential seal.
5. Screw the Front Cover Seal Remover T74P-6700-A and forcing screw into the metal seal protector using a 1 inch box wrench.
NOTE: The differential fluid seal is a two-piece seal constructed of an outer metal protector and inner rubber seal.
6. Tighten the screw on the end of the tool using a 3/4 inch box wrench until the outer metal seal protector is removed. Remove the metal seal
protector from the tool and discard.
7. Install Front Cover Seal Remover T74P-6700-A and forcing screw into the seal portion using a 1 inch box wrench.
8. Tighten the screw on the end of the tool using a 3/4 inch box wrench until the seal portion is removed and discard the seal.
9. Install Front Cover Seal Remover T74P-6700-A and 5 1/2 inch forcing screw (from tool kit T88T-6701-A) into RH differential seal.
10. Screw the Front Cover Seal Remover T74P-6700-A and forcing screw into the metal seal protector using a 1 inch box wrench.
NOTE: The differential fluid seal is a two-piece seal constructed of an outer metal protector and inner rubber seal.
11. Tighten the screw on the end of the tool using a 3/4 inch box wrench until the outer metal seal protector is removed. Remove the metal seal
protector from the tool and discard.
12. Install Front Cover Seal Remover T74P-6700-A and forcing screw into the seal portion using a 1 inch box wrench.
