Taurus V6-30L Drive Chain Cover Replacement
3. Place end of bimetal with hole over front retaining pin. Install bimetal retaining collars.
4. Place Bimetal Height Gauge T86P-70422-AR
Bi-metal Metal Strip Installation
5. Gently tap retaining collar onto pin until it seats against tool edge.
6. Engage slotted end of bimetal under rear retaining pin and retaining collar and then repeat Steps 5 and 6 for slotted end of bimetal.
7. Remove slotted end of bimetal from its pin. Position plate slotted ends onto rear and middle retaining pins. Install slotted end of bimetal under
retaining collar.
