Taurus AWD V6-3.5L (2009)
Seats with an OCS system service kit
8. Disconnect the OCS system service kit electrical connector.
Power seats with an OCS system service kit
9. Remove the tie strap retaining the unused pressure sensor electrical connector from the seat wiring harness.
All seats
10. NOTICE: Do not oversize the seat cushion frame holes used to rivet the Occupant Classification System Module (OCSM) in place.
Failure to follow this instruction may result in component damage and/or system failure.
Using a 5 mm (3/16 in) drill, remove the 2 rivets and the OCSM from the seat cushion frame bracket.
Seats with an OCS system service kit
11. NOTE: Make note of the opening that the OCS system service kit components are being fed through on the seat cushion support assembly for
installation purposes.
Remove the OCS system service kit from the seat cushion frame.
-
Remove any tie straps securing wire harnesses or electrical connectors.
-
Feed the hose, pressure sensor, wire harness, electrical connector and OCSM through the seat cushion frame support assembly.
