Taurus X FWD V6-3.5L (2008)
7. Position the instrument cluster finish panel and upper steering column shroud.
8. NOTE: If equipped, make sure that the in-vehicle temperature sensor assembly is connected to the instrument cluster finish panel to ensure that
dual-zone electronic automatic temperature control (EATC) operates correctly.
Connect the in-vehicle temperature sensor assembly.
9. Install the 2 instrument cluster finish panel screws.
10. Install the lower steering column shroud.
-
Clip the lower steering column shroud to the upper steering column shroud.
-
Install the 3 screws.
11. Install the steering column cover.
-
Install the 3 screws.
12. Repower the SRS.
13. Verify that the horn operates by pushing each corner of the driver air bag module.
If the horn does not operate, remove the driver air bag module following the steps in this procedure and check the following:
1
that each horn contact is in the correct position in the steering wheel armature.
2
that the steering wheel switches connector is connected to the clockspring assembly.
3
that the horn wire connectors in the upper RH of the steering wheel armature are connected.
-
If the 3 items are OK, check the horn for faults. Refer to Horn.
