Taurus X FWD V6-3.5L (2008)
4. Release the clamp and disconnect the power steering fluid reservoir-to-pump supply hose from the power steering pump.
^
Detach the supply hose retainer from the power steering pressure line bracket.
5. Disconnect the fuel efficient power steering (FEPS) solenoid electrical connector.
6. Remove the power steering pressure line bracket-to-engine bolt.
7. Remove the 3 power steering pump bolts.
8. Holding the power steering pump with a suitable holding device, disconnect the power steering pressure line fitting-to-power steering pump.
Installation
1. CAUTION: new Teflon(R) seal must be installed any time the power steering pressure line is disconnected from the power steering pump
or a fluid leak may occur.
Using the special tool, install a new Teflon(R) seal on the power steering pressure line fitting.
2. Holding the power steering pump with a suitable holding device, connect the power steering pressure line fitting-to-power steering pump.
^
Tighten to 57 Nm (42 lb-ft).
3. Position the power steering pump and install the 3 bolts.
^
Tighten to 25 Nm (18 lb-ft).
4. Position the bracket and install the power steering pressure line bracket-to-engine bolt.
^
Tighten to 10 Nm (89 lb-inch).
5. Connect the FEPS solenoid electrical connector.
