Thunderbird V8-302 5.0L HO (1992)
13. Gently slide buckle assembly forward out of track assembly.
14. Remove buckle assembly from drive belt.
INSTALLATION
Prior to installation, lubricate track using suitable grease.
1. Insert drive belt at front of track assembly, then install buckle assembly into large slot at front end of drive belt.
2. Slide drive belt and buckle assembly into track assembly far enough to allow installation of A-pillar limit switch and bracket assembly, then secure
switch and bracket.
3. Install drive belt into vertical guide.
4. Rotate thumb wheel on motor clockwise to feed drive belt through motor guide and into lower guide.
5. Rotate track assembly downward at rear and position retaining tab on A-pillar limit switch bracket into forward hole in A-pillar. Then rotate track
assembly upward.
6. Engage vertical guide retaining tab into B-pillar bracket. Install but do not tighten screw and bolts used to secure track assembly to roof rail and
A-pillar.
7. Secure B-pillar bracket to B-pillar and tighten attaching bolts to 22-33 Nm (17-24 lb-ft).
8. Tighten A-pillar limit switch attachment to 4.5-7.0 (40-62 lb-in).
9. Install and tighten bolt retaining vertical guide to inner quarter panel sheet metal to 4.5-7.0 (40-62 lb-in).
10. Reconnect electrical connectors at A- and B-pillars limit switches.
11. Install quarter trim panel and A-pillar moldings.
12. Cycle mini buckle to B-pillar position.
13. Insert tongue of shoulder belt into mini buckle. Ensure there is no twist in belt.
14. Ensure proper operation of restraint system.
Lap Safety Belt Retractor