ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Fuel Filter - 1.8L Duratorq-TDDi (Lynx) Diesel > < Fuel Filter - 1.8L Duratec-DOHC (Zetec)
Fuel Tank and Lines - Fuel Tank Filler Pipe Transit/Tourneo Connect 2002.5 (06/2002-)
Removal and Installation

WARNING:
WARNING:Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
WARNING:
WARNING:This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to follow these instructions may result in personal injury.
  1. Drain the fuel tank. For additional information, refer to Section  310-00A Fuel System - General Information.
  1. Remove the right-hand rear road wheel. For additional information, refer to Section  204-04 Wheels and Tires.

3. Remove the components in the order indicated in the following illustration(s) and table(s).

 
Item
Part Number
Description
1
-
Fender splash shield
2
-
Fuel tank filler cap
3
-
Fuel tank filler pipe retaining bolt
5
6
-
Fuel tank filler pipe

4. To install, reverse the removal procedure.

Removal Details

Item 4 : Fuel tank vent hose

  1. Raise the vehicle.

Item 5 : Fuel tank filler hose

CAUTION:
CAUTION:When removing the fuel tank filler hose or fuel tank vent hose, do not use any sharp edged tools to lever off the hoses. Failure to follow this instruction may cause damage to the filler hose or vent hose.
NOTE:
NOTE:Make a note of the position of the fuel tank filler hose retaining clamp.

Installation Details

Item 5 : Fuel tank filler hose

NOTE:
NOTE:The fuel tank filler hose retaining clamp must be installed in the same position as removed.

Item 4 : Fuel tank vent hose

  1. Partially lower the vehicle.

Fuel Filter - 1.8L Duratorq-TDDi (Lynx) Diesel > < Fuel Filter - 1.8L Duratec-DOHC (Zetec)