ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Start Inhibitor Switch - Remove and Install (17 694 0) > < Solenoid - Downshift - Remove and Install (17 687 0)

Transit 1995 (08.1994-07.2000)

Cable - Downshift - Adjust (17 682 0)Transit 1995 (08/1994-07/2000)
Print Print
Removal and Installation
Workshop Equipment
Test equipment FDS 2000
1. Connect the FDS 2000 tester.
• Open the interior fuse box.
• Pull off the bezel holding the spare fuses.
2. Carry out the testing using the FDS 2000 programme and make any adjustment which may be necessary.

3. Raise the vehicle.
4. Adjust the downshift cable.
1. Undo the bolts on the kickdown solenoid.
2. Slide the activated kickdown solenoid in the slots until there is free play of between 0,3 mm and 0,8 mm between the kickdown lever on the transmission and the kickdown solenoid.

5. Tighten the kickdown solenoid bolts.
   Check the transmission kickdown lever free play. Repeat the adjustment if necessary (see step ).
6. Lower the vehicle.
7. Disconnect the FDS 2000 tester, re‐fit the bezel and close the fuse box.

Start Inhibitor Switch - Remove and Install (17 694 0) > < Solenoid - Downshift - Remove and Install (17 687 0)