ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Fuel Pressure Regulator Filter Element > < Fuel Tank Mounting Frame

Transit 1995 (08.1994-07.2000)

Fuel Tank Filler ValveTransit 1995 (08/1994-07/2000)
Print Print
Removal and Installation
Remove

WARNING:

Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.

WARNING:

The fuel tank manual valves must be closed and fuel line pressure released before attempting any repairs. Failure to follow this instruction may result in personal injury.

1. Depressurize the CNG system. For additional information, refer to Fuel System Pressure Release in this section.

2. Disconnect the start inhibit switch electrical connector.

3. Disconnect the CNG shrouding from the fuel tank filler valve (one clamp).

4. Disconnect the high‐pressure fuel line from the fuel tank filler valve.

5. Remove the filler cap.

6. Remove the fuel tank filler valve.
Install

WARNING:

Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.

WARNING:

The fuel tank manual valves must be closed and fuel line pressure released before attempting any repairs. Failure to follow this instruction may result in personal injury.

NOTE:

Make sure a waterproof seal is made around the filler lip using body mastic. Clean off excess sealer when clamped.

7. To install, reverse the removal procedure.
8. Check the system for leaks. For additional information, refer to High‐Pressure Leak Test and Low‐Pressure Leak Test in this section.

Fuel Pressure Regulator Filter Element > < Fuel Tank Mounting Frame