ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Crankshaft Rear Seal > < In-vehicle Repair|Oil Pan

Transit 2000.5 (01.2000-05.2006)

Engine - 2.3L DOHC-16V - Oil Pump Transit 2000.5 (01/2000-05/2006)
In-vehicle Repair

General Equipment
2.5 mm drill bit

Removal
  1. NOTE:
    NOTE:Only turn the engine in the normal direction of rotation.
    Turn the engine to bottom dead center (BDC).
  1. Remove the engine front cover.
    For additional information, refer to Engine Front Cover in this section.

  1. Detension and lock the oil pump chain tensioner.
    1. Retract the pawl.
    1. Insert a 2.5 mm drill bit.

  1. Remove the oil pump chain tensioner.

  1. Remove the oil pump chain guides.
  1. Remove the oil pump chain.

  1. Remove the oil pump sprocket.

  1. Remove the oil pump.

Installation
  1. Install the oil pump.

  1. Install the oil pump sprocket.
  1. Check the alignment of the balance shaft gears.

  1. CAUTION:
    CAUTION:The copper links of the timing chain must align with the timing marks on the crankshaft sprocket and the balance shaft sprocket.
    Install the oil pump chain.

  1. Install the oil pump chain guides.

  1. Install the oil pump chain tensioner.

  1. Unlock the oil pump chain tensioner by removing the drill bit.
  1. Install the engine front cover.
    For additional information, refer to Engine Front Cover in this section.

Crankshaft Rear Seal > < In-vehicle Repair|Oil Pan