ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Fuel Charging and Controls > < Throttle Body

Transit 2000.5 (01.2000-05.2006)

Fuel Charging and Controls - 2.3L DOHC-16V - Fuel Injection Supply Manifold Transit 2000.5 (01/2000-05/2006)
Removal and Installation

Materials
Name
Specification
Engine oil
WSS-M2C913-A or WSS-M2C912-A1 

Removal

  1. Release the fuel system pressure. For additional information, refer to Section  310-00A Fuel System - General Information / 310-00B Fuel System - General Information.
  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.
  1. Remove the throttle body.
    For additional information, refer to Throttle Body in this section.

  1. Disconnect the engine wiring harness electrical connector.

  1. Disconnect the fuel injector electrical connectors.

  1. Remove the fuel supply and return line retaining bracket.

  1. Disconnect the fuel supply and return lines. For additional information, refer to Section  310-00A Fuel System - General Information / 310-00B Fuel System - General Information.

  1. Remove the fuel injection supply manifold.
    • Discard the O-ring seals.

  1. Remove numbers one, two and three fuel injectors.
    • Discard the O-ring seals.

  1. Remove the fuel pressure regulator.
    • Discard the O-ring seal.

  1. Remove number four fuel injector.
    • Discard the O-ring seal.

Installation

  1. NOTE:
    NOTE:Install new fuel injector and fuel pressure regulator O-ring seals.
    NOTE:
    NOTE:Coat the fuel injector and fuel pressure regulator O-ring seals with clean engine oil.
    To install, reverse the removal procedure.

Fuel Charging and Controls > < Throttle Body