ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Ignition Signal Filter > < Fuel Temperature Sensor - 2.4L Duratorq-TDCi (Puma) Diesel

Transit 2000.5 (01.2000-05.2006)

Electronic Engine Controls - Injector Driver Module (IDM)—2.0L Duratorq-TDCi (Puma) Diesel Transit 2000.5 (01/2000-05/2006)
Removal and Installation

General Equipment
Worldwide Diagnostic System (WDS)

Removal

NOTE:
NOTE:If a new IDM is being installed connect WDS. Upload the IDM configuration information using the programable modules installation routine prior to commencing the removal of the IDM.
  1. Remove the instrument panel. For additional information, refer to Section  413-17 Tachograph.

  1. Detach the wiring harness.

  1. Remove the IDM retaining nuts.

  1. Detach the IDM from the bulkhead.
    • Remove the retaining nut.

  1. Remove the IDM security shield.
    • Drill out the steel rivets.

  1. NOTE:
    NOTE:Support the IDM when disconnecting the electrical connectors.
    Disconnect the IDM electrical connectors.

  1. NOTE:
    NOTE:Support the IDM when disconnecting the electrical connector.
    Disconnect the IDM electrical connector.

  1. Remove the IDM retaining bracket from the IDM.
    • Drill out the steel rivets.

Installation

NOTE:
NOTE:If a new IDM is being installed connect WDS. Download the IDM configuration information using the programable modules installation routine after the installation of the IDM.
NOTE:
NOTE:Install new steel rivets.
  1. To install, reverse the removal procedure.

Ignition Signal Filter > < Fuel Temperature Sensor - 2.4L Duratorq-TDCi (Puma) Diesel