ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
High-Pressure Cutoff Switch - 2.0L Duratorq-Di (Puma) Diesel-2.0L Duratorq-TDCi (Puma) Diesel-2.0L Duratorq-TDDi (Puma) Diesel > < Low-Pressure Cutoff Switch

Transit 2000.5 (01.2000-05.2006)

Air Conditioning - High-Pressure Cutoff Switch—2.3L DOHC-16V/2.4L Duratorq-Di (Puma) Diesel/2.4L Duratorq-TDCi (Puma) Diesel Transit 2000.5 (01/2000-05/2006)
Removal and Installation

Removal

  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Disconnect the high-pressure cutoff switch electrical connector.

  1. CAUTION:
    CAUTION:Make sure that the high-pressure cutoff switch valve is completely closed following removal to prevent loss of refrigerant.
    Remove the high-pressure cutoff switch.
    • Discard the O-ring seals.

Installation

  1. NOTE:
    NOTE:Install new high-pressure cutoff switch O-ring seals.
    NOTE:
    NOTE:Coat the high-pressure cutoff switch O-ring seals in clean refrigerant oil prior to installation.
    To install, reverse the removal procedure.

High-Pressure Cutoff Switch - 2.0L Duratorq-Di (Puma) Diesel-2.0L Duratorq-TDCi (Puma) Diesel-2.0L Duratorq-TDDi (Puma) Diesel > < Low-Pressure Cutoff Switch