| General Procedures | | -
NOTE:This procedure only works if two or more programmed ignition keys are available and it is desired to program additional key(s). If two keys are not available. For additional information, refer to Key Programming-Erase All Keys and Program Two Keys in this section. NOTE:The Spare Key Programming Switch is a WDS/FDS 2000 programmable switch which provides the capability to enable/disable the normal customer Spare Key Programming Procedure. If the Spare Key Programming Switch is not enabled , refer to Security Access then select Spare Key Programming Switch; Enabled. NOTE:If the programming procedure is not successful, the new key(s) will not start the vehicle and the anti-theft indicator will flash. If the programming procedure was not successful leave the ignition switch in the RUN position for at least 30 seconds, repeat the Key Programming procedure from step 1. If the failure repeats, refer to Diagnostic and testing to review DTCs an carry out Pinpoint Tests. NOTE:A maximum of eight ignition keys can be programmed to a passive anti-theft system (PATS) equipped vehicle. NOTE:If the steps are not carried out as outlined, the programming procedure will end. NOTE:Ignition keys must have correct mechanical key cut for the vehicle and must be a PATS encoded key. Insert the first programmed key into the ignition lock cylinder and turn the lock cylinder from the OFF position to the RUN position (maintain ignition lock cylinder in the RUN position for one second). | | | -
Turn ignition lock cylinder to the OFF position and remove the first key from the ignition lock cylinder. | | | -
Within five seconds of turning the ignition lock cylinder to the OFF position, insert the second programmed ignition key into the ignition lock cylinder and turn the ignition lock from the OFF position to the RUN position (maintain the ignition lock cylinder in the RUN position for one second). | | | -
Turn the ignition lock cylinder to the OFF position and remove the second key from the lock cylinder. | | | -
Within ten seconds of turning the ignition lock cylinder to the OFF position, insert the unprogrammed ignition key (new key) into the lock cylinder and turn the lock cylinder from the OFF position to the RUN position (maintain the ignition lock cylinder in the RUN position for less than 5 seconds). | | | -
Check the new programmed key starts the engine. Turn the ignition key to the OFF position for five seconds then try to start vehicle with the new programmed key. | | | -
To programme additional key(s), repeat the applicable key programming procedure from step 1. | | |
