General Procedures | -
Loosen the sliding door striker plate retaining bolts. | | -
Loosen the sliding door guide retaining bolts. | | -
Loosen the sliding door lower arm inner and outer adjustment screws. | | -
NOTE:Make sure that the sliding door is in the fully closed position. Check the alignment of the sliding door in relation to the B-pillar and for any excessive gap in the top corners. | | -
Adjust the top roller adjustment screw to align the sliding door in relation to the B-pillar if necessary. | | -
NOTE:Make sure that the sliding door is in the fully closed position. Check the alignment of the sliding door in relation to the B-pillar. | | -
From the outside of the vehicle insert 6 mm margin blades between the lower edge of the sliding door and the body, and between the left-hand edge of the sliding door and the C-pillar. | | -
From the inside of the vehicle, loosen the center roller retaining bolts. | | -
With the aid of another technician, push the rear of the sliding door until it aligns with the C-pillar and tighten the center roller retaining bolts. | | -
Remove the 6 mm margin blades. | | -
Tighten the sliding door striker plate retaining bolts. | | -
NOTE:Make sure that the sliding door is in the fully closed position. Check the alignment of the sliding door. | | -
With the aid of another technician, push the front of the sliding door until it aligns with the B-pillar and tighten the lower arm outer adjustment screw. | | -
Tighten the lower arm inner adjustment screw. | | -
NOTE:Make sure that the sliding door is in the fully closed position. Check the alignment of the sliding door. | | -
Tighten the sliding door guide retaining bolts. | | |