ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Sliding Door Latch > < Hood Latch
Handles, Locks, Latches and Entry Systems - Front Door Latch Transit 2000.5 (01/2000-05/2006)
Removal and Installation

Removal

All vehicles
  1. Remove the front door trim panel. For additional information, refer to Section  501-05 Interior Trim and Ornamentation.

  1. NOTE:
    NOTE:Do not touch the adhesive surface as re-bonding will be impaired.
    Detach the watershield from the front door panel.
  1. Remove the front door lock cylinder (if equipped).
    For additional information, refer to Front Door Lock Cylinder in this section.

  1. Detach the front door latch remote control handle.
    1. Unclip the door latch remote control handle.
    1. Remove the cable tie.
Vehicles with central locking

  1. Disconnect the front door lock actuator electrical connector.
All vehicles

  1. Remove the front door glass top run outer retainer bracket.

  1. Disconnect the exterior front door handle actuating rod.
    • Open the clip and pull out the actuating rod.

  1. Remove the front door latch and remote control assembly.

  1. Disconnect the front door remote control cable.
    1. Detach the outer cable.
    1. Disconnect the inner cable.

Installation

  1. To install, reverse the removal procedure.

Sliding Door Latch > < Hood Latch