Windstar V6-232 3.8L (1995)
Removal
1. Remove rear seats.
2. Remove anchor bolt attaching rear safety belt.
3. Remove screw attaching holder for rear safety belt.
4. Remove door lock switch opening cover.
5. Remove door lock switch.
6. Remove two screws and two luggage cover retainers.
7. Remove rear body side trim panel.
8. Remove nut retaining holder for front safety belt.
9. Remove B-pillar trim panel by pulling to release fasteners.
10. Remove C-pillar trim panel pushpins. Pull C-pillar trim panel to release fasteners and remove trim panel.
11. Pull clips and pushpins attaching quarter trim panel to body.
12. Disconnect electrical connector to remote headphone module and A/C controls (if equipped).
13. Remove quarter trim panel.
Installation
1. Follow removal procedure in reverse order.
Rear Upper Trim Panel
