Windstar V6-232 3.8L (1995)
Parts Replacement Chart
1. Pass the rear safety belt and retractor assembly through opening of quarter trim panel.
2. Position belt and retractor assembly to vehicle and secure with bolt. Install a new bolt with the same part number as indicated in the Parts
Replacement Chart. Tighten to 30-40 Nm (22-30 lb-ft).
NOTE: Make sure tab is secure in quarter trim panel before securing with screws.
3. Position quarter trim panel and secure with screws.
4. Position sling and secure with bolt. Install a new bolt with the same part number as indicated under Specifications. Tighten to 30-40 Nm (22-30
lb-ft).
5. Position anchor to step well and secure with bolt. Install a new bolt with the same part number as indicated in the Parts Replacement Chart.
Tighten to 30-40 Nm (22-30 lb-ft).
6. Install safety belt retractor cover bolt access plug.
7. Position rear safety belt retractor cover and secure with screws.
8. Check the restraint system for proper operation.
Safety Belts, Front Seats Outboard