Canyon 2WD L4-2.9L (2008)
Turn Signal Switch: Service and Repair
Turn Signal Multifunction Switch Replacement
Turn Signal Multifunction Switch Replacement
Removal Procedure
Important: The turn signal multifunction switch and Inflatable restraint steering wheel module coil are serviced as an assembly.
1. Remove the steering wheel. Refer to Steering Wheel Replacement (See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Steering Wheel Replacement) .
2. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement (See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Column Trim Covers Replacement) .
3. Disconnect any electrical connectors and remove the wiring harness from any retainers as needed.
4. Remove the turn signal multifunction switch bolts.
5. Slide the multifunction turn signal switch off of the steering column.
Installation Procedure
Important: A new multifunction turn signal switch will come precentered with a centering tab attached. Do NOT remove the centering
tab until installation is complete. Failure to follow procedure will cause a misalignment of the multifunction turn signal switch and
centering will be required.
If reusing the existing multifunction turn signal switch, you must center it. Refer to Inflatable Restraint Steering Wheel Module Coil
Centering (See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Procedures) .
1. Slide the multifunction turn signal switch onto the steering column.
