gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Body Control Module|Diagrams > < Engine Controls - Vehicle Will Not Start, Dead Battery|Page 277
Page 1
background image

Body Control Module: All Technical Service Bulletins
Wipers/Washers - Phantom Wiper Operation

TECHNICAL

Bulletin No.: 08-08-43-007

Date: April 14, 2008

Subject: 
Phantom Windshield Wiper Operation (Reprogram Body Control Module)

Models:
2008 Chevrolet Colorado
2008 GMC Canyon

Condition

Some customers may comment that the windshield wipers intermittently wipe without being commanded to operate. This condition may occur at start up
or while driving the vehicle.

Cause

This condition may be caused by electrical noise that causes the Body Control Module (BCM) to activate the windshield wipers.

Correction

A revised calibration has been developed to address this condition. Technicians are to reprogram the BCM with the latest software available on
TIS2WEB. Refer to the Service Programming System (SPS) and Body Control Module Programming and Setup procedures in SI for additional
information. As always make sure your Tech 2(R) is updated with the latest software version.

Warranty Information

For vehicles repaired under warranty, use the table.

Disclaimer

Body Control Module|Diagrams > < Engine Controls - Vehicle Will Not Start, Dead Battery|Page 277