Canyon 2WD L5-3.5L VIN 6 (2004)
Seals and Gaskets: Service and Repair
Transmission Input Shaft Seal Replacement
Transmission Input Shaft Seal Replacement
^
Tools Required
-
J 45866 Input Shaft Seal Installer
Removal Procedure
1. Remove the transmission input shaft bearing retainer.
2. Using a hammer and a punch, remove the input shaft seal from the input shaft bearing retainer.
Installation Procedure
1. Using the J 45866 and a hammer, install the input shaft seal into the input shaft bearing retainer.
^
The spring side of the seal goes toward the tool
^
Ensure the seal is installed square
^
The tool will install the seal to the correct depth
2. Install the transmission input shaft bearing retainer.