Canyon 4WD L5-3.7L (2007)
Shift Boot: Service and Repair
Control Lever and/or Boot Replacement
Removal Procedure
1. Remove the shift lever assembly. Refer to Shift Lever Assembly Replacement (D06) Shift Lever Assembly Replacement (W/O D06).
2. Remove the console (w/o D06 only). Refer to Console Replacement (Small W/ Manual Transmission).
3. Remove the control lever boot screws.
4. Tilt and remove the control lever boot from the control lever.
5. Shift the transmission into NEUTRAL.
6. Remove the control lever housing assembly bolts.
7. Remove the control lever housing assembly and gasket.
8. Mask off the control lever housing opening, in order to prevent foreign objects from entering the transmission.
9. Disassemble the control lever housing if necessary. Refer to Shift Control Housing Disassemble.
Installation Procedure
1. Assemble the control lever housing if previously disassembled. Refer to Shift Control Housing Assemble.
2. Remove the masking from the control lever opening and ensure the sealing surface is clean and dry.
