Canyon 4WD V8-5.3L (2009)
Constant Velocity Joint Boot: Service and Repair
Wheel Drive Shaft Inner Joint and Boot Replacement
Wheel Drive Shaft Inner Joint and Boot Replacement
Special Tools
*
J 35910 Drive Axle Seal Clamp Plier
*
J 8059 Snap Ring Pliers
Removal Procedure
Note: Before placing the driveshaft in a vise, place protective covers over the vise jaws.
1. Place the driveshaft in a vise.
Note: Do not damage the D/O joint housing while using the hand grinder.
2. Use a hand grinder to cut through the large retaining clamp (2) located at the D/O joint (1).
