Canyon 4WD V8-5.3L (2009)
5. Install the control lever housing assembly bolts and tighten to 20 Nm (15 lb ft).
6. Slide the boot into position over the control lever.
Note: Ensure the carpet is not between the boot and the floor panel.
7. Tilt the boot in order to seat to the floor.
8. Install the control lever boot screws and tighten to 2.5 Nm (22 lb in).
9. Install the console (w/o D06 only). Refer to Console Replacement (Large w/Manual or Auto Transmission) (See: Body and Frame/Interior
Moulding / Trim/Console/Service and Repair)Console Replacement (Small w/Manual Transmission) (See: Body and Frame/Interior Moulding /
Trim/Console/Service and Repair).
10. Install the shift lever assembly. Refer to Shift Lever Assembly Replacement (w/o D06) (See: Shifter M/T/Service and Repair/Shift Lever
Assembly Replacement (w/o D06))Shift Lever Assembly Replacement (D06) (See: Shifter M/T/Service and Repair/Shift Lever Assembly
Replacement (D06)).
