Envoy 2WD L6-4.2L (2008)
11. Remove the end of the range selector cable (1) from the floor control ball stud.
12. Remove the range selector cable (2) from the floor shift control assembly.
13. Remove the tape and grommet on the shift cable from the floor panel.
14. Remove the range selector cable (3) from the vehicle.
Installation Procedure
1. Push the cable down through the floor panel and install the grommet (2).
2. Install the range selector cable (2) to the floor shift control assembly.
3. Install the end of the range selector cable (1) to floor control ball stud.
4. Install the drivers side front mat and carpet. Refer to Front Floor Panel Carpet Replacement .
