Envoy 2WD V8-5.3L (2007)
Pinion Bearing: Service and Repair
Drive Pinion Bearings Replacement
Tools Required
^
J 7817 Outer Bearing Race Installer
^
J 7818 Inner Bearing Race Installer
^
J 8092 Universal Driver Handle - 3/4 in - 10
^
J 8608 Rear Pinion Bearing Race Installer
^
J 8611-01 Rear Pinion Bearing Race Installer
^
J 8614-01 Flange and Pulley Holding Tool
^
J 22306 Rear Pinion Clip Bearing Installer
^
J 22912-B Split-Plate Bearing Puller
^
J 24433 Pinion Cone and Side Bearing Installer
^
J 36614 Pinion Cone and Side Bearing Installer
^
J 33782 Pinion Oil Seal Installer
^
J 38694 Extension Housing Oil Pump/Seal Installer
^
J 45871 Pinion Bearing Remover
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the differential. Refer to Differential Replacement.
3. Remove the drive pinion from the axle. Refer to Drive Pinion and Ring Gear Replacement.
4. For the 8.0 inch axle, press the bearing off of the pinion using the J 22912-B.
5. For the 8.6 inch axle, install the J 45871 (1) around the pinion bearing and the J 22912-B (2) in the inverted position around the J 45871.
