Envoy 2WD V8-5.3L VIN M (2005)
9. Disconnect the grommet from the end gate to access the washer hose connection.
10. Cut the exposed ends of the washer hose from the body wiring harness.
11. Remove the hose from the vehicle.
INSTALLATION PROCEDURE
1. Install the washer hose to the vehicle.
2. Route the hose along the body wiring harness.
3. Tape the washer hose to the body wiring harness with 3 wraps of electrical tape, every 100 mm (4 in).
4. Roll the carpet back into place along the floor panel.
5. Install the rear compartment anchors.
6. Install the rear seat backs.
7. Install the right front sill plate.
8. Connect the washer hose connection at the end gate.
9. Connect the pass-through grommet at the end gate.
10. Install the left rear quarter upper trim panel.
11. Install the rear washer hose out through the bulkhead, and seat the grommet (1).
12. Connect the rear washer hose connection (2) near the coolant tank.
