G 2500 3/4 Ton Van V8-6.5L DSL Turbo VIN F (1996)
-
Rotate the retaining ring out of the position on the connector and remove completely.
-
Pull on the cooler line and remove the connector from the fitting.
3. Remove the oil cooler line from the vehicle.
INSTALL OR CONNECT
1. Position the cooler lines to the vehicle.
Important: The figure depicts the improper installation of the retainer ring to the connector fitting. Failure to follow the proper installation
procedure could result in cooler line separation from the connector fitting.
2. Install the retaining rings (E-clips) onto the two quick connect fittings by using the following procedures:
-
Obtain a "NEW" retaining ring for assembly.
