K 1500 Truck 4WD V8-393 6.5L DSL VIN P (1995)
Drive/Propeller Shaft: Service and Repair
This article has been updated with Bulletin No.: 56-41-01
PROPELLER SHAFT REPLACEMENT (FRONT DRIVE)
REMOVE OR DISCONNECT
-
Raise vehicle on hoist.
-
Skid plate (if applicable).
-
Reference mark the relationship of the propeller shaft to the front axle and the transfer case.
IMPORTANT: It is essential that the positions of all driveline components relative to the propeller shaft and axles be observed and accurately
reference marked prior to disassembly. These components include the propeller shafts, drive axles, pinion flanges, output shafts, etc. All
components must be reassembled in the exact relationship to each other as they were when removed. In addition, published specifications and
torque values, as well as any measurements made prior to disassembly, must be followed.
1. Bolts and retainers from front axle.
2. Bolts and retainers from transfer case.
IMPORTANT: Do not pound on to disconnect.
3. Propeller shaft.
-
Compress the propeller shaft forward, enough to disengage, then move the propeller shaft rearward.
-
Avoid dropping cap assemblies from the yoke ends.
CLEAN
-
All parts with an approved solvent.
INSPECT
-
Splines for damage, wear, burrs, and twisting.
-
Universal joint bearings for wear.
-
Propeller shaft for any evidence of damage.
INSTALL OR CONNECT
-
Extend the propeller shaft to its full length, then compress it about half its stroke.
1. Propeller shaft to front axle.
