K 1500 Truck 4WD V8-393 6.5L DSL VIN P (1995)
Tighten
-
Crimp seal retaining clamp (12) with J 35910 to 136 Nm (100 lbs. ft.).
3. Spacer ring (8) on the front axle shaft (13) and beyond the second groove as shown in the illustration.
-
Slide the tripot spider assembly against the spacer ring (8) and the shaft (13).
Important
-
Be sure that the counterbored face of the tripot spider (3) faces the end of the shaft (13).
4. Shaft retaining ring (2) in the groove of the axle shaft (13) with J 8059.
5. Slide the tripot spider (3) towards the end of the shaft (13) and reseat the spacer ring (8) in the groove on the axle.
A. Place approximately half of the grease provided in the seal (10) and use the remainder to repack the tripot housing (1).
6. Pinch the swage ring (9) by hand slightly to distort it into an oval shape and slide it onto the large diameter of the seal (12).
7. Slide the tripot housing (1) over the tripot spider assembly on the shaft (13).
8. Slide the large diameter of the seal (10) with the large swage ring (9) in place over the outside of the tripot housing (1) and locate the seal lip in the
housing groove.
