K 1500 Truck 4WD V8-5.3L VIN T (2000)
CAUTION:
^
Refer to Inflator Module Disposal Caution in Cautions and Notices.
^
When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed. Failure to follow the
procedures in the order listed may result in personal injury.
Deploy the inflatable restraint steering wheel inflator module outside of the vehicle when the vehicle will be returned to service. Situations that require
deployment outside of the vehicle include the following:
^
Using the SIR diagnostics, you determine that the inflator module does not function properly.
^
The inflator module is scratched or ripped on the cover.
^
The inflator module pigtail (if equipped) is damaged.
^
The inflator module connector is damaged.
^
An inflator module connector terminal is damaged.
Deployment and disposal of a malfunctioning inflator module is subject to any required retention period.
IMPORTANT: Refer to the latest General Motors Service Bulletins before deploying a steering wheel inflator module.
1. Turn the ignition switch to the OFF position.
2. Remove the ignition key.
3. Put on safety glasses.
4. Inspect the J 38826 SIR Deployment Harness and the appropriate pigtail adapter for damage. Replace as needed.
5. Short the two SIR deployment harness (1) leads together using one banana plug seated into the other.
6. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
7. Remove the inflatable restraint steering wheel module.
8. Remove all horn/steering wheel control buttons from the module, if equipped.
CAUTION: Refer to Inflator Module Handling And Storage Caution in Cautions and Notices.
9. Place the module with the vinyl trim cover facing up and away from the surface on a work bench.
