K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
14. Remove the crankshaft balancer from the crankshaft.
15. Remove the crankshaft position sensor from the engine front cover.
16. Remove the fuel injection drive gear from the camshaft.
17. Remove the fuel injection pump mounting bolts.
18. Remove the bolts from the engine front cover and the oil pan, please refer to Engine, Cooling and Exhaust/Engine/Engine Lubrication/Oil Pan,
Engine/Service and Repair/ See: Engine Lubrication/Oil Pan/Service and Repair
IMPORTANT: Mark the fuel line clips, so that they can be re-installed on the proper stud.
19. Remove the fuel line clips from the studs.
20. Remove the engine front cover from the engine block.
INSTALLATION PROCEDURE
