K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
Wiper Motor: Service and Repair
Wiper Motor Module Replacement
REMOVAL PROCEDURE
1. Disconnect the electrial connector from the wiper motor.
2. Remove the three screws and the wiper motor cover.
3. Remove the module from the wiper motor.
INSTALLATION PROCEDURE
1. Install the module in the wiper motor.
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the wiper motor cover with the three screws.
Tighten
Tighten the three screws to 2.6 N.m (23 lb in).
3. Connect the electrial connector to the wiper motor.
