K 2500 Yukon 4WD V8-6.0L VIN U (2000)
REMOVAL PROCEDURE
1. Remove the door handle bezel.
2. Remove the window regulator handle, if equipped.
3. Remove the trim panel screws.
4. Remove the trim panel from the door by carefully sliding the panel upward then out.
INSTALLATION PROCEDURE
1. Connect the electrical connectors, if necessary.
2. Align the retainers with the holes in the door.
3. Install the trim panel to the door by lowering the trim panel down into the retainer holes in order to seat the retainers.
4. Install the window regulator handle, as necessary.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the trim panel screws.
Tighten
Tighten the trim panel screws to 2 N.m (18 lb in).
6. Install the door handle bezel.
Rear Door Trim Panel Replacement
Rear Door Trim Panel Replacement
Removal Procedure
1. Remove the upper trim panel.
2. Slide the trim panel upward to disengage the mounting hooks.
3. Remove the trim panel from the rear door.
Installation Procedure
