K Yukon/Denali 4WD V8-5.7L VIN R (2000)
Cruise Control Switch: Description and Operation
The ACCELERATE Function
Use the ACCELERATE function in order to steadily increase the cruise speed. In order for the ACCELERATE function to operate, the following
conditions must apply:
^
The ON/OFF switch must be in the ON position
^
The vehicle speed must be above 40 km/h (25 mph).
Use the ACCELERATE function as follows to increase the vehicle speed:
1. Slide the RESUME/ACCELERATE switch. Hold the switch in position.
2. Accelerate the vehicle to the desired speed.
3. Release the RESUME/ACCELERATE switch. The cruise control is now reset at the higher speed.
The ACCELERATE function will not operate unless the ON/OFF switch is in the ON position
The COAST (Trim) Function
use the COAST/TRIM function in order to raise or lower the cruise control speed. Use the COAST (Trim) function in the following manner to increase
the vehicle speed:
1. Accelerate the vehicle to a higher speed.
2. Fully depress the SET/COAST button. The VCM will release the previously set speed.
3. Release the SET/COAST button. The cruise control is now set at the higher speed.
Use the COAST (Trim) function as follows in order to decrease the vehicle speed:
1. Fully depress the SET/COAST button to disengage the cruise control system.
2. Allow the vehicle to slow to the desired speed.
3. Release the SET/COAST button. The cruise control is now reset at the lower speed.
THE ON/OFF Switch
The multifunction lever contains the ON/OFF position slide switch. The switch controls electrical power to the cruise control system. When the switch is
OFF, you can not engage the system. When the switch is ON, you can engage the cruise control system using either the SET or RESUME switch. The
cruise control system will not function at speeds less than approximately 40 km/h (25 mph).
The RESUME Function
Use the RESUME function in order to reactivate the cruise control system after the system has been disengaged by pressing the brake pedal.
Momentarily depressing the RESUME/ACCEL switch will reactivate the system, causing the vehicle to accelerate to the previously set speed.
The RESUME function will not operate under the following circumstances:
^
The ON/OFF switch has been cycled since the last time the cruise control was active.
^
The ignition has been switched OFF since the last time the cruise control was active.
^
The vehicle speed is below the minimum speed of 40 km/h (25 mph) required for the operation of the cruise control system.
The RESUME/ACCEL Switch
The RESUME/ACCEL switch controls the following 3 functions:
^
The RESUME function
^
The ACCELERATE function
^
The TAP UP function
The SET Function
Use the SET function in order to set the cruise control at a particular speed. Engage the SET function in the following manner:
1. Ensure that the vehicle speed is above the low speed point.
2. Place the ON/OFF switch in the ON position.
3. Depress and release the SET/COAST switch
The cruise speed will be set within 1.6 km/h (1 mph) of the speed the vehicle was travelling when you released the button. The vehicle will continue to
cruise until one of the following events occurs:
^
The ON/OFF switch is moved to the OFF position
^
The ignition switch is turned OFF
^
The SET/COAST switch is pushed in fully and held.
Depressing the brake pedal will also disengage the cruise control. However, when you use this method, the memory retains the set speed, allowing the
cruise control function to resume at a later time.
The SET/COAST Switch
