K Yukon/Denali 4WD V8-5.7L VIN R (2000)
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the starter mounting bolts and washers, through the starter to the engine.
Tighten
Tighten the starter mounting bolts to 45 N.m (33 lb ft).
2. Install the wiring harness and the battery positive cable to the starter.
Tighten
-
Tighten the battery cable to the solenoid to 10 N.m (89 lb in).
-
Tighten the ignition switch wires to the solenoid to 2 N.m (18 lb in).
3. Install the snap-on starter shield as necessary. Ensure that the shield is aligned properly.
