K Yukon/Denali 4WD V8-5.7L VIN R (2000)
8. For two-piece Dana propeller shafts, pull the slip yoke (4) out of the stub shaft (1).
9. For two-piece American Axle and Manufacturing propeller shafts, unscrew the threaded cap on the center slip yoke.
10. Remove the propeller shaft.
10.1.
Slide the propeller shaft forward.
10.2.
Lower the propeller shaft and remove the propeller shaft.
10.3.
Do not allow the universal joint to incline greatly. The joint may fracture.
11. Remove the center bearing support bolts.
12. Remove the center support bearing nuts and washers.
13. Remove the center bearing support (3).
14. Remove the front propeller shaft.
14.1.
Support the propeller shaft.
14.2.
Do not allow the universal joint to bend deeply as the universal joint could fracture.
14.3.
Remove the propeller shaft with a rearward movement.
15. Clean all parts with an approved solvent.
16. Inspect the outer diameter of the transmission yoke for burrs. Burring damages the transmission seal.
17. Inspect the slip yoke splines for wear.
18. Inspect for twisted slip yoke splines or possibly the wrong universal joint.
19. Inspect the universal joint bearings for wear. Replace as necessary.
Installation Procedure
