K Yukon/Denali 4WD V8-6.5L DSL Turbo VIN S (1999)
8. Position the clamp on the pump end of the power steering cooler (6).
9. Install the power steering cooler (6) to the power steering pump.
-
Tighten the clamp on the power steering cooler (6). Fully crimp the clamp until zero gap between both halves is achieved prior to springback.
10. Install the power steering cooler (6) to the power steering gear.
-
Tighten the power steering cooler (6) at the power steering gear to 27 Nm (20 ft. lbs.).
11. Remove the drain pan from under the vehicle.
12. Bleed the power steering system.
